Triton t300si remote electric shower manual

Thank you for your recent enquiry. The Data lead cable supplied should not be extended as this may impair the performance and operation of the unit. Regards, Karl. Answered by: Triton Showers. How long is the control cable? The Data link cable is approx.

Shower Flow Rate 3. Counted in the purchase are a flexible shower hose and head. There are five showerhead Spray patterns. Multiple spray patterns usually deliver a more discrete showering experience. The water runs for a limited second to flush out already heated water before stopping completely.

It is ideal for the next user protection and to avert limescale build-up. Before manual operation of the triton tsi shower, the commissioning and purge pin dealings must be adequately completed. A low-pressure indicator provides warning LED lights if water pressure becomes too short, disturbing the performance.

During regular operation of the triton tsi shower, if an overheat temperature is detected, the power to the elements will be abridged. Water will continually flow from the electric shower. When the weather gets cooled satisfactorily, the details will inevitably be restored to the earlier setting at the time of disruption. Tsi trips switch in fuse box. No power in showe unit. Tsi 8. Triton Tsi Solinoid valve not opening. Neutral fault. Solenoid replaced but shower still dripping.

Triton si constantly dripping. Lights not on. I have got a Triton si - indicator of low pressure flushing. Smell of burning. No light on panel in shower and shower not working. Shower Head. Lack of Temperature Control. Shower drips constantly out of the shower head. Shower clicks when turn power on at spur. Water flowing from outside overflow.

Shower flicks between hot and cold. Cold water and low pressure light. Water too hot. Low Water Pressure Warning Light. Power to unit no water. Too hot! Triton Tsi-water temperature the same on high and economy settings.

Triton si wireless remote Triton TSi 9. Tsi remote. Triton si - Start then Stop. Low pressure and cold water light on with no water. No power to control panel. Triton si control PCB fault? Control panel. Ti - Pulse of water only when switched on. Triton Tsi Tripping. Triton Tsi Tepid water. T si. T si burning wire. Page 32 Tsi wireless remote electric shower make sure the backplate is square on the wall Fig.

Turn on the mains water supply and check for leaks in the pipework connection to the remote pack. The cable entry points are shown in Fig. The cable can be surface clipped, hidden or via 20mm conduit. Drill and plug the wall. Using the screws supplied, secure the mounting bracket to the wall Fig. This will link the control panel to the specific remote pack.

It will take about thirty seconds for a smooth flow of water to be obtained while air and any debris in the system is being flushed from the shower. Failure to do so will damage the unit and invalidate the guarantee. High power button To start the shower note: When first switched on at the isolation switch, the shower will attempt to initialise itself.

Page Operating The Shower Tsi wireless remote electric shower The lower button is for cold water only. To adjust the shower temperature In the event of abnormal operation which could cause unsafe temperatures within the unit, the device will disconnect the heating elements. It will require a Adjust the spray pattern by turning the bezel on the showerhead in either direction until the desired pattern is obtained.

The hardness of the water will determine the frequency of cleaning. It is essential that this operation is carried out by a competent person. Description Part no. Terminal block 9. Page Fault Finding Tsi wireless remote electric shower faulT finDinG Important: Switch oFF the electricity at the mains supply and remove the circuit fuse before attempting any fault finding inside the unit.

Check supply. Remove light on and low correctly. Print page 1 Print document 48 pages.